- An Antique Ammeter
- Removing the Internal Components
- Drilling and Tapping for the Back Plate
- An Electrical Plug is Attached
- Neon and Electrical Work
- Pictures of the Completed Teslapunk Night Light
This Teslapunk night light was inspired by the sub genre of Steampunk. You can see more about Teslapunk here.
An Antique Ammeter
This is a vintage ammeter I picked up at a flea market over the summer. I had this idea to make it into a Teslapunk style night light for the hallway outside my bedroom.
This is the back side.
Removing the Internal Components
When taken apart you can see it has a lot of area inside, or at least it will have when I remove the components.
This is the inside of the top with everything removed. I decided to remove all the brass pins on the surface that were used to mount the internals and the dial face.
Drilling and Tapping for the Back Plate
I then drilled and tapped the brass plugs that were left from the pins so I could remount the dial face again only deeper inside the lens and bezel.
Because there was a third brass plug left at the top I added another 4-40 brass mounting screw to this location.
This is the meter with the dial face remounted in its new lower position.
Meter with the lens and bezel set back in place. Now I have enough space to add a high brightness neon bulb inside at the bottom of the face. The neon will light up the face and reflect nicely outward. I chose a neon bulb for a bunch of reasons. They run off of mains power (120VAC), they draw very little current (~1.3mA), they last a long time and they look really vintage.
An Electrical Plug is Attached
So now I need to get power into my light. After mulling several ideas I came up with using the plastic back of a wall plug in transformer.
I took it apart and trimmed it down so that it would fit inside the meter housing.
Next I notched the brass plate from the back of the meter to fit around the raised plug area of the plastic transformer plate.
Then I drilled three holes to allow the plastic plug plate to be securely attached to the brass meter back. The plastic was also drilled to allow the mounting screw for the brass plate to go through the plastic.
The meter is now ready to be wired with a neon bulb. The warm glow of neon is perfect for Teslapunk. Unfortunately I did not have any neon bulbs in stock so I ordered some along with a small 125VAC toggle switch that will also be mounted on the light. Got these from Digikey an electronic parts supplier. These should be here Monday so until then I cannot complete the night light.
Neon and Electrical Work
This is the switch and neon bulb I purchased from Digikey. The bulb also needed a 33K ohm 1/4 watt resistor wired in series with it in order to get the proper voltage to the bulb. The bulb runs on about 90VAC.
The housing was drilled and milled on one side to accept the toggle switch and retaining screw.
Here the switch is mounted.
The leads for the neon bulb were inserted through existing holes.
Everything was soldered together.
Then the light and switch were tested.
The face was put back on.
The lens cover was reattached.
When tested the brightness was too dim with just one bulb. The switch is rated for 3 amps. The current draw of the neon bulbs is so is only 1.2mA, that’s 0.012A so the switch can handle something like 250 neon bulbs in parallel.
Pictures of the Teslapunk Night Light
So I added two more bulbs. Each with its 33k ohm drop down resistor.
Another view. Now that looks Teslapunk.
One in the dark.
Finally one with the switch off.